After adding a single MPEG2 clip (a VHS capture) and defining my chapter set points, I can not figure out how to proceed to the next step - the \'Menu\' setup screen.  

After clicking \'OK\" it just returns to the main Chapter Cut Edit screen.  I can\'t find anything that is equivalent to a NEXT button that would allow me to continue to the \'Menu\' screen and the only buttons shown at the top are \'Clip Information\' and \'Chapter Cut Edit\'  which just keep me going round in a loop.

I\'ve read the TMPGEnc DVD Author GUIDE here at Afonic, but it doesn\'t address my specific question.

The answer is probably all too obvious so, I\'ll be embarassed in advance.   :oops:

TRIASSIC

Thanks for your reply Afonic.

I found the source of my problem was that I was running a lower screen resolution of 800 x 600 rather than the recommended and therefore, my task bar was hiding the \'OK\" button at the bottom of the Chapter Cut Edit page.  No wonder I couldn\'t exit from that page....  the OK button was hidden!!!

Such a simple solution.  It drove me crazy for two days until I discovered my error.

Successfully authored my first disc and burned it with Nero.

Thanks!